} el SHARP. apm PERSONAL Tom a COMPUTER q “—— a PC-3000 SERIES eee IilWWwoWd W FCC STATEMENT WARNING - FCC Regulations state that any un- harmful interference to radio or television recep- authorized changes or modifications to this equip- tion, which can be determined by turning the equip- ment not expressly approved by the manufacturer ment off and on, the user is encouraged to try to could void the user's authority to operate this correct the interference by one or more of the equipment. following measures: Note: This equipment has been tested and found « Reorient or relocate the receiving antenna. to comply with the limits for a Class B digital device ¢ Increase the separation between the equip- pursuant to Part 15 of the FCC Rules. ment and receiver. These limits are designed to provide reasonable « Connect the equipment into an outlet on a protection against harmful interference in a circuit different from that to which the receiver is connected. residential installation. This equipment generates, ¢ Consult the dealer or an experienced uses and can radiate radio frequency energy and, if not installed and used in accordance with the radio/TV technician for help. instructions, may cause harmful interference to A shielded I/F cable is required to insure com- radio communications. However, there is no pliance with FCC regulation for Class B computing guarantee that interference will not occur in a par- equipment. ticular installation. If this equipment does cause Included with this computer are a serial conversion and a parallel conversion cable. These cables are provided to assure that the computer complies with FCC Class B certification. For handling instructions of these cables, see Chapter 14 in this OPERATION MANUAL. —— Copyright ©1991 Distributed Information Processing Limited and Sharp Corporation. This document contains or refers to proprietary information which is protected by copyright. All rights are reserved. Copying or other reproduction of this document is prohibited without the prior written permission of Sharp Corporation. Trademarks IBM PC, XT and AT are trademarks of International Business Machines Corporation. Microsoft and MS-DOS are trademarks of Microsoft Corporation. Intel is a trademark of Intel Corporation. Lotus and Lotus 1-2-3 are trademarks of Lotus Development Corporation. LapLink is a trademark of Traveling Software, Inc. Notice Information in this manual is subject to change without notice and does not represent a commitment on the part of Sharp Corporation. Sharp Corporation shall not be liable for technical or editorial errors or omissions contained herein; nor for incidental or consequential damages resulting from the furnishing, performance, or use of this material. NOTICE SHARP strongly recommends that separate permanent written records be kept of all important data. Data may be lost or altered in virtually any electronic memory product under certain circumstances. Therefore, SHARP assumes no responsibility for data lost or otherwise rendered unusable whether as a result of improper use, repairs, defects, battery replacement, use after the specified battery life has expired, or any other cause. SHARP assumes no responsibility, directly or indirectly, for financial losses or claims from third persons resulting from the use of this product and all of its functions, such as stolen credit card numbers, the loss of or alternation of stored data, etc. ° The information provided in this manual is subject to change without notice. LIMITED USE LICENSE AGREEMENT You should carefully read the following terms and conditions before using the Microsoft MS-DOS software and all other software provided with the computer (the "Software". This is a legal document which constitutes the agreement between you, the end user, and Sharp Corporation for the use of the Software. Using the Software indicates your acceptance of the terms of this Agreement, which includes the Limited Use Software License and Limited Warranty. LIMITED USE SOFTWARE LICENSE In consideration of the license fee, which is a part of the price you paid for the computer, Sharp Corporation, as Licensor, grants to you, the Licensee, a non-exclusive software license to use the Software and related documentation supplied herein. The terms of this license are as follows. 1. You may use the Software on a single computer at a single location. 2. As the Licensee, you own the magnetic or other physical media on which the Software is recorded, but Sharp Corporation or its licensors retains title and ownership of the Software recorded on the original disk copies and all subsequent copies of the Software, regardless of the form or media in or on which the original and other copies may exist. This License is not a sale of the original Software or any copy thereof. 3. You and your employees and agents are required to protect the copyright of the Software and license for this Software. You may NOT distribute or otherwise make the Software or documentation available to any third party, by time-sharing or otherwise, without the prior written consent of Sharp Corporation. You may be held legally responsible for any copyright infringement that is caused or encouraged by your failure to abide by the terms of this Agreement. 4. You may NOT modify or alter the Software. Any portion of the Software that is merged into or used in conjunction with another software will continue to be the property of Sharp Corporation or its licensors and will be subject to the terms of this Agreement. 5. You are permitted to copy the Software for exclusive use as your working copy. Any such copy must contain the same copyright notice and proprietary marking as the original Software. 6. You may not transfer or assign the Software or this License to any other person without the prior written consent of Sharp Corporation. Any authorized transferee of the Software shall be bound by the same terms and conditions of this Agreement and, in such case your License is automatically terminated. In no event may you transfer, assign, rent, sell, or otherwise dispose of the Software on a temporary or permanent basis except as expressly provided herein. 7. This License is effective until terminated. This License will terminate automatically without notice from Sharp Corporation if you fail to comply with any provision of this Agreement. Upon termination you shall destroy the Software together will all copies and modifications in any form. 8. The restrictions in this license are for the benefit of the party who holds title to any part of the Software. SOFTWARE LIMITED WARRANTY Sharp Corporation and its licensors provide the Software with no warranty and makes the Software and media available solely on an “AS IS” basis. In no event shall Sharp Corporation or its licensors be liable or in any way responsible for any incidental or consequential economic or property damage caused by using the Software. However, if a modified version of the Software is released within one year from the Software release, Sharp Corporation shall make reasonable effort to provide you with information concerning the modified version. YOU ACKNOWLEDGE THAT YOU HAVE READ THIS AGREEMENT AND UNDERSTOOD IT, AND THAT BY USING THE SOFTWARE YOU AGREE TO BE BOUND BY ITS TERMS AND CONDITIONS. YOU FURTHER AGREE THAT, EXCEPT FOR SEPARATE WRITTEN AGREEMENTS BETWEEN SHARP CORPORATION AND YOU, THIS AGREEMENT IS THE COMPLETE AND EXCLUSIVE STATEMENT OF THE RIGHTS AND LIABILITIES OF THE PARTIES CONCERNED. THIS AGREEMENT SUPERSEDES ALL PRIOR ORAL AGREEMENTS, PROPOSALS OR UNDERSTANDINGS, AND ANY OTHER COMMUNICATIONS BETWEEN US RELATING TO THE SUBJECT MATTER OF THIS AGREEMENT. Pere a a A a Welcome If you are new to the family of Sharp products, welcome. To ali new owners of this computer, congratulations. You have purchased one of the most powerful and easy-to-use personal computers available today. Using advanced technology, we packed the power of larger PCs into this compact pocket sized model. Your new Sharp computer features a superlative LCD with CGA emulation and a suite of built-in applications. There are two models of this unit, each with a different memory configuration. Unless otherwise specified, descriptions in this manual apply to both models. The available model varies depending on countries. a LL For Your Records For safekeeping and easy reference, fill in the model and serial numbers (from the back of the computer), as well as any other pertinent information in the space below. Model number: Serial number: Date of purchase: Place of purchase: Password: Contents Chapter 1 Starting with the Basics 1-1 The Hardware 1-4 Connectors and Compartments 1-5 IC Memory Card Drives 1-5 Memory Organization 1-6 Internal Disk Drives 1-7 The Software Chapter 2 Setting Up 2-1 Guidelines & Precautions 2-1 Installing the Main Batteries 2-2 Installing the Backup Battery 2-3 Cautions when Changing Batteries 2-4 Turning On 2-4 Turning Off Chapter 3 Getting Started 3-1 System Start-up 3-1 Initial Installation 3-7 Customizing Your System Chapter 4 Introducing the Applications 4-1 Introduction 4-1 Setting the Scene 4-1 Updating your Address Book 4-4 Agreeing on a Time 4-4 Saving your Address Book 4-5 Updating your Schedule 4-6 Storing the Diary 4-7 Preparing a Forecast (Worksheet) 4-10 Producing the Agenda (Editor) 4-14 The Alarm 4-14 Conclusion Chapter 5 Using Applications 5-1 Introduction 5-1 Selecting the Software to Use 5-3 Screen Layout 5-4 Using Function Keys 5-5 Using Help 5-5 Movement Keys 5-6 Line Editing Keys 5-6 Replying to Prompts 5-7 Using Menus 5-7 Using Printing 5-14 Using Files 5-19 Using the Clipboard 5-20 Using Undelete Chapter 6 The Pop Up Menu 6-1 Introduction 6-1 Displaying the Pop Up Menu 6-1 Using the Pop Up Menu 6-2 Leaving the Pop Up Menu 6-3 The Calculator 6-6 The Desk Clock 6-7 To Do List 6-10 Pop Up Menu Options 6-15 Customizing the Pop Up Menu Chapter 7 Using MS-DOS 7-1 What is MS-DOS 7-1 What are Files 7-1 Naming Files 7-2 Saving Files 7-2 Starting MS-DOS 7-3 Using the Keyboard 7-5 Using Commands 7-7 Directories 7-8 Configuration Files 7-9 The Standard MS-DOS Commands 7-9 The Extra Commands 7-10 ATTRIB (File attributes) 7-11 DIAG (Diagnostics) 7-11 FORMAT (Format IC memory card /diskette) 7-12 KSIM (Simulate keypresses) 7-13 KSIMCOMP (Compile file for KSIM) 7-15 LEARN (Record keystrokes for KSIM) 7-15 OFF (Turn off) 7-16 PASSWORD (System password) 7-16 REBOOT (Reboot system) 7-17 SETUP (Hardware setup) Chapter 8 LapLink Utility 8-1 What is LapLink 8-1 Setting Up 8-3 LapLink Screen 8-4 Making Selections 8-4 Executing LapLink Commands 8-5 Using LapLink 8-12 LapLink Error Messages Chapter 9 The Address Book 9-1 Introduction 9-4 Adding Cards 9-5 Moving Around the Address Book 9-6 Editing Cards 9-6 Deleting Cards 9-7 Filing 9-8 Searching 9-9 Selecting Cards 9-9 Printing 9-11 Address Book Options 9-12 Summary Chapter 10 The Scheduler 10-1 Introduction 10-6 Adding Entries 10-8 Editing Entries 10-8 Deleting Entries 10-9 Repeating Entries 10-9 Alarms 10-10 Filing 10-11 Searching 10-11 Moving Entries 10-12 Printing 10-13 Scheduler Options 10-14 Summary Chapter 11 The Editor 11-1 Introduction 11-3 Typing 11-4 Moving Around the Text 11-4 Editing 11-5 Searching 11-7 Formatting 11-10 Filing 11-11 Printing 11-12 Editor Options 11-13 Summary Chapter 12 The File Manager 12-1 Introduction